Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 952/1523
10.3.5 ets pg-mapping
This command configures the mapping list of priority to priority groups. The range of priority id is from 0
to 7. The priority groups are LAN, SAN and IPC. This command let you assign priority id to specific
priority group. When the ETS is enabled, priority id 0 to 2 are assigned to LAN, priority 3 to 6 are
assigned to SAN, and priority 7 is assigned to IPC.
ets pg-mapping {lan|san|ipc} [<0-7> [<0-7> [<0-7> [<0-7> [<0-7> [<0-7> [<0-7>]]]]]]]
no ets pg-mapping
<0 - 7> - Priority Id from 0 to 7.
lan - Sets ETS Priority Id to LAN priority group
san - Sets ETS Priority Id to SAN priority group
ipc - Sets ETS Priority Id to IPC priority group
no - This command restores the priority to priority group mapping list to default value.
Default Setting
Priority id 0 to 2 in LAN, 3 to 6 in SAN and 7 in IPC
Command Mode
Data-Center-Bridging Interface Mode
To Next Page
Loading...
Need help?
General