Quanta Computer T5016-LB8D - Configuration Commands

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 977/1523
10.7.2 Configuration Commands
10.7.2.1 vmtracer session
This command places the switch in vmtracer mode for the specified session. The command creates a
new session or loads an existing session for editing.
The switch supports total four VM Tracer sessions.
Syntax
vmtracer session <Session_Name>
no vmtracer session <Session_Name>
no - This command removes a existed VM Tracer session.
<Session_Name> - The label assigned to the VM Tracer session.
Default Setting
None
Command Mode
Global Config
When the switch in vmtracer mode, it can configure the following commands:
 allow-vlan
 autovlan disable
 exit (vmtracer mode)
 password (vmtracer mode)
 url
 username (vmtracer mode)