_____________________________________________________________________________
LB9 User’s Guide 261/1523
6.3.15 Service Port Commands
6.3.15.1 show serviceport
This command displays service port configuration information.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface Status: Indicates whether the interface is up or down.
IP Address: The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask: The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway:The default gateway for this IP interface. The factory default value is 0.0.0.0.
IPv6 Administrative Mode: Whether enabled or disabled. Default value is enabled.
IPv6 Prefix is: The IPv6 address and length. Default is Link Local format.
IPv6 Default Router: The default gateway address on the service port. The factory default value is
an unspecified address.Configured IPv4 Protocol: Indicate what IPv4 network protocol was used
on the last, or current power-up cycle, if any.
Configured IPv6 Protocol: Indicate what IPv6 network protocol was used on the last, or current
power-up cycle, if any.
IPv6 AutoConfig Mode: Whether enabled or disabled. Default value is disabled.
IPv6 Link-local Scope ID: The scope ID for this interface
Burned In MAC Address: The burned in MAC address used for in-band connectivity.
To Next Page
Loading...
Need help?
General