Quanta Computer T5016-LB8D - Managing Dynamic ARP Inspection (DAI)

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 1156/1523
11.3.17 Managing Dynamic ARP Inspection (DAI)
11.3.17.1 Configuring DAI Global Configuration Page
Configurable Data
Validate Source MAC - Choose the DAI Source MAC Validation Mode for the switch by selecting
Enable or Disable from the pull down menu. If you select Enable, Sender MAC validation for the ARP
packets will be enabled. The factory default is disable.
Validate Destination MAC - Choose the DAI Destination MAC Validation Mode for the switch by
selecting Enable or Disable from the pull down menu. If you select Enable, Destination MAC
validation for the ARP Response packets will be enabled. The factory default is disable.
Validate IP - Choose the DAI IP Validation Mode for the switch by selecting Enable or Disable from
the pull down menu. If you select Enable, IP Address validation for the ARP packets will be enabled.
The factory default is disable.
Command Buttons
Submit - Update the switch with the values you entered. If you want the switch to retain the new
values across a power cycle you must perform a save.