_____________________________________________________________________________
LB9 User’s Guide 601/1523
6.20.4 Service Commands
The 'service' command set is used in DiffServ to define:
Traffic Conditioning Assign a DiffServ traffic conditioning policy (as specified by the policy
commands) to an interface in the incoming direction.
Service Provisioning Assign a DiffServ service provisioning policy (as specified by the policy
commands) to an interface in the outgoing direction
The service commands attach a defined policy to a directional interface. Only one policy may be
assigned at any one time to an interface in a particular direction. The policy type (in, out) must match the
interface direction to which it is attached.
This set of commands consists of service addition/removal.
The CLI command root is service-policy
To Next Page
Loading...