Quanta Computer T5016-LB8D - Cos (Class of Service) Command; Show Commands

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 632/1523
6.23 CoS (Class of Service) Command
6.23.1 Show Commands
6.23.1.1 show queue cos-map
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a
specific interface. The slot/port parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If specified, the 802.1p mapping table of the interface is
displayed. If omitted, the most recent global configuration settings are displayed.
Syntax
show queue cos-map {<slot/port> | port-channel <portchannel-id>}
< slot/port > - The interface number.
<portchannel-id> - The port-channel interface number. The range of the ID is 1 to 64.
Default Setting
None
Command Mode
Privileged EXEC
User EXEC
Display Message
The following information is repeated for each user priority.
User Priority: The 802.1p user priority value.
Traffic Class: The traffic class internal queue identifier to which the user priority value is mapped.