_____________________________________________________________________________
LB9 User’s Guide 1417/1523
11.7.6 Viewing DHCPv6 Client Parameters
Selection Critieria
Interface - Select the interface for which data is to be displayed.
Non-Configurable Data
Lease Parameters
Client State - The State of the DHCPv6 Client on this interface. The valid values are:INACTIVE,
SOLICIT, REQUEST, ACTIVE, RENEW, REBIND, RELEASE.
Server DUID - The DHCPv6 Unique Identifier of the DHCPv6 Server on this interface.
T1 Time (Sec) - The T1 (in seconds) time as indicated by the DHCPv6 Server. T1 value indicates
the time interval after which the address is requested for renewal.
T2 Time (Sec) - The T2 (in seconds) time as indicated by the DHCPv6 Server. T2 value indicates
the time interval after which the Client sends Rebind message to the Server incase there are no
replies to the Renew messages.
Interface IAID - An identifier for an identity association chosen by this Client.
Prefix - The IPv6 Prefix leased by the DHCPv6 Server for this interface.
Prefix Length - The Prefix length corresponding to the IPv6 Prefix leased by the DHCPv6 Server.
Prefer LifeTime (Sec) - The preferred life time (in seconds) of the IPv6 Address leased by the
DHCPv6 Server.
Valid LifeTime (Sec) - The valid life time (in seconds) of the IPv6 Address leased by the DHCPv6
Server.
To Next Page
Loading...
Need help?
General