_____________________________________________________________________________
LB9 User’s Guide 1368/1523
11.6.5 Managing IP Helper
11.6.5.1 Configuring Global IP Helper
Configurable Data
UDP Relay Mode - Select enable or disable from the pull down menu. User must enable Relay
Mode to relay any other protocols for which an IP helper address has been configured. By Default
UDP Relay Mode is disabled.
Remove - Removes the specified UDP Relay when selected and "Submit" is pressed.
Command Buttons
Add - Used to add UDP Relay/Helper IP configuration.
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
To Next Page
Loading...
Need help?
General