Quanta Computer T5016-LB8D - Configuration Commands

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 438/1523
6.9.2 Configuration Commands
6.9.2.1 cdp
This command is used to enable CDP Admin Mode.
Syntax
cdp
no cdp
no - This command is used to disable CDP Admin Mode.
Default Setting
Enabled
Command Mode
Global Config
6.9.2.2 cdp run
This command is used to enable CDP on a specified interface.
Syntax
cdp run
no cdp run
no - This command is used to disable CDP on a specified interface.
Default Setting
Enabled
Command Mode
Interface Config