EasyManua.ls Logo

Quanta Computer T5016-LB8D - Congestion-Notify CPID

Default Icon
1523 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 958/1523
10.4.7 congestion-notify CPID
The user can go to the CLI Global Configuration Mode to configure the device identifier of CPID. Use the
congestion-notify CPID devid <value>’ global configuration command. Use the ‘no congestion-notify
CPID devid’ to configure device identifier to default value.
Syntax
congestion-notify CPID devid < 0-16777215 >
no congestion-notify CPID devid
<0-16777215> - This command sets the Device ID of CPID
no - This command configure device identifier to default value.
Default Setting
0
Command Mode
Global Data-Center-Bridging Mode
The user can go to the CLI Global Configuration Mode to configure the LSB field of CPID of CNM
payload. Use the ‘congestion-notify CPID LSB Q_No’ global configuration command to set the CPID
mode to use queue number of sampled packet. Use the ‘congestion-notify LSB CPIndex’ to configure
device identifier to use congestion point index.
Syntax
congestion-notify CPID LSB { CPIndex | Q_No}
CPIndex - This command configures queue number of sampled packet.
Q_No - This command sets congestion point index.
Default Setting
Q_No
Command Mode
Global Data-Center-Bridging Mode

Table of Contents