_____________________________________________________________________________
LB9 User’s Guide 434/1523
6.9 CDP (Cisco Discovery Protocol) Commands
6.9.1 Show Commands
6.9.1.1 show cdp
This command displays the CDP configuration information.
Default Setting
None
Command Mode
Privileged Exec
Display Message
CDP Admin Mode: CDP enable or disable
CDP Holdtime (sec): The length of time a receiving device should hold the L2 Network Switch CDP
information before discarding it
CDP Transmit Interval (sec): A period of the L2 Network Switch to send CDP packet
Ports: Port number vs CDP status
CDP: CDP enable or disable
To Next Page
Loading...
Need help?
General