Quanta Computer T5016-LB8D User Manual

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 699/1523
7.3 Open Shortest Path First (OSPF) Commands
7.3.1 Show Commands
7.3.1.1 show ip ospf
This command displays information relevant to the OSPF router.
Syntax
show ip ospf
Default Setting
None
Command Mode
Privileged Exec
Display Messages
!
Some of the information below displays only if you enable OSPF and configure certain
features.
Router ID : A 32-bit integer in dotted decimal format identifying the router, about which information is
displayed. This is a configured value.
OSPF Admin Mode : Shows whether the administrative mode of OSPF in the router is enabled or
disabled. This is a configured value.
RFC 1583 Compatibility : Indicates whether 1583 compatibility is enabled or disabled. This is a
configured value.
External LSDB Limit : The maximum number of non-default AS-external-LSA (link state
advertisement) entries that can be stored in the link-state database.
Exit Overflow Interval : The number of seconds that, after entering overflow state, a router will
attempt to leave overflow state.
Spf Delay Time : The number of seconds between two subsequent changes of LSAs, during which
time the routing table calculation is delayed.
Spf Hold Time: The number of seconds between two consecutive spf calculations.
Opaque Capability: Shows whether the router is capable of sending Opaque LSAs. This is a
configured value.
Autocost Ref BW: Shows the value of auto-cost reference bandwidth configured on the router.
Default Passive Setting: Shows whether the interfaces are passive by default.
Maximum Paths: The maximum number of paths that OSPF can report for a given destination.

Quanta Computer T5016-LB8D Specifications

General

Brand	Quanta Computer
Model	T5016-LB8D
Category	Switch
Language	English