_____________________________________________________________________________
LB9 User’s Guide 1183/1523
11.3.21 Managing MLD Snooping Querier
11.3.21.1 Configuring MLD Snooping Querier Configuration Page
Use this menu to configure the parameters for MLD Snooping Querier, Note that only a user with
Read/Write access privileges may change the data on this screen.
Configurable Data
Snooping Querier Admin Mode - Select the administrative mode for MLD Snooping for the switch
from the pull-down menu. The default is disable.
Snooping Querier Address - Specify the Snooping Querier Address to be used as source address
in periodic MLD queries. This address is used when no address is configured on the VLAN on which
query is being sent.
MLD Version - Specify the MLD protocol version used in periodic MLD queries.
Query Interval (secs) - Specify the time interval in seconds between periodic queries sent by the
snooping querier. The Query Interval must be a value in the range of 1 and 1800. The default value
is 60.
Querier Expiry Interval (secs) - Specify the time interval in seconds after which the last querier
information is removed. The Querier Expiry Interval must be a value in the range of 60 and 300. The
default value is 60.
Configurable Data
Submit - Update the switch with the configured values.
Refresh - Reload the information on the page.
To Next Page
Loading...
Need help?
General