_____________________________________________________________________________
LB9 User’s Guide 1049/1523
11.2.8.3 Configuring SNMP EngineID
This menu will display an entry for configuring remote EngineID.
Selection Criteria
IP Address - You can use this screen to reconfigure an existing host, or to create a new one. Use
this pull-down menu to select one of the existing host, or select 'Create' to add a new one.
Configurable Data
Protocol - Select IPv4 or IPv6 to configure the corresponding attributes.
IP Address - Enter the IP address of SNMP host which will receive SNMP trap/inform from this
switch. Enter 4 numbers between 0 and 255 separated by periods.
Engine ID - Enter new or changed Engine ID for the selected host. The Engine ID is up to 24
hexadecimal characters in length.
Command Buttons
Submit - Update the switch with the values on this screen. If you want the switch to retain the new
values across a power cycle, you must perform a save.
Delete - Delete the currently selected SNMP Engine ID. If you want the switch to retain the new
values across a power cycle, you must perform a save.
To Next Page
Loading...
Need help?
General