Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 105/1523
This command configures the port priority assigned for untagged packets for all ports presently plugged
into the device. Any subsequent per port configuration will override this configuration setting.
switchport priority all <0-7>
no switchport priority all
<0-7> - The range for the priority is 0-7.
all – All interfaces
no – This command restores the priority value to default value for all interfaces.
Default Setting
0
Command Mode
Global Config
6.2.3.22 switchport protocol group
This command adds the physical interface to the protocol-based VLAN identified by <group-name>. A
group may have more than one interface associated with it. Each interface and protocol combination can
only be associated with one group. If adding an interface to a group causes any conflicts with protocols
currently associated with the group, this command will fail, and the interface(s) will not be added to the
group.
switchport protocol group <group-name>
no switchport protocol group <group-name>
<group-name> - a VLAN Group Name (a character string of 1 to 16 characters).
no - This command removes the interface from this protocol-based VLAN group that is identified by
this <group-name>.
Default Setting
None
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General