_____________________________________________________________________________
LB9 User’s Guide 1056/1523
11.2.8.8 Captive Portal Trap Flags Page
Non-Configurable Data
Client Authentication Failure Traps - If you enable this field, the SNMP agent sends a trap when a
client attempts to authenticate with a captive portal but is unsuccessful.
Client Connection Traps - If you enable this field, the SNMP agent sends a trap when a client
authenticates with and connects to a captive portal.
Client Database Full Traps - If you enable this field, the SNMP agent sends a trap each time an
entry cannot be added to the client database because it is full.
Client Disconnection Traps - If you enable this field, the SNMP agent sends a trap when a client
disconnects from a captive portal.
Command Buttons
Submit - Update the switch with the values on the screen. If you want the switch to retain the new
values across a power cycle you must perform a save.
Refresh - Refresh the data on the screen with the present state of the data in the switch.
To Next Page
Loading...