EasyManuals Logo

Quanta Computer T5016-LB8D User Manual

Default Icon
1523 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1090 background imageLoading...
Page #1090 background image
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 1090/1523
sFlow Receiver Maximum Datagram Size - The maximum number of data bytes that can be sent
in a single sample datagram.
sFlow Receiver Address - The IP address of the sFlow collector.
sFlow Receiver Port - The destination port for sFlow datagrams.
sFlow Receiver Datagram Version - The version of sFlow datagrams that should be sent.
Command Buttons
Submit - Send the updated data to the switch and cause the changes to take effect on the switch.
Refresh - Refresh the data on the screen with present state of data in the switch.
11.2.14.3 Configuring sFlow Poller Configuration Page
sFlow agent collects time-based sampling of network interface statistics and sends them to the
configured sFlow receivers. A data source configured to collect counter samples is called a poller.
Selection Criteria
Poller Datasource(Slot/Port) - sFlowDataSource for this sFlow sampler. This Agent will support
Physical ports only.
Configurable Data
Receiver Index - The sFlowReceiver associated with this counter poller. Allowed range is (1 to 8 )
Poller Interval - The maximum number of seconds between successive samples of the counters
associated with this data source. A sampling interval of 0 disables counter sampling. Allowed range
is (0 to 86400 secs)
Non-Configurable Data
Poller DataSource - The interface for which data is being displayed.
Receiver Index - The sFlowReceiver for this sFlow Counter Poller. If set to 0, the poller
configuration is set to default and the poller is deleted. Only active receivers can be set. If a receiver
expires then all pollers associated with the receiver will also expire. Allowed range is (1 to 8 )
Poller Interval - The maximum number of seconds between successive samples of the counters
associated with this data source.
Command Buttons
Submit - Send the updated data to the switch and cause the changes to take effect on the switch.
Refresh - Refresh the data on the screen with present state of data in the switch.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quanta Computer T5016-LB8D and is the answer not in the manual?

Quanta Computer T5016-LB8D Specifications

General IconGeneral
BrandQuanta Computer
ModelT5016-LB8D
CategorySwitch
LanguageEnglish