_____________________________________________________________________________
LB9 User’s Guide 1382/1523
11.6.7.2 Viewing Router Discovery Status
Non-Configurable Data
Interface - The router interface for which data is displayed.
Advertise Mode - The values are enable or disable. Enable denotes that Router Discovery is
enabled on that interface.
Advertise Address - The IP Address used to advertise the router.
Maximum Advertise Interval (secs) - The maximum time (in seconds) allowed between router
advertisements sent from the interface.
Minimum Advertise Interval (secs) - The minimum time (in seconds) allowed between router
advertisements sent from the interface.
Advertise Lifetime (secs) - The value (in seconds) used as the lifetime field in router
advertisements sent from the interface. This is the maximum length of time that the advertised
addresses are to be considered as valid router addresses by hosts.
Preference Level - The preference level of the router as a default router relative to other routers on
the same subnet. Higher numbered addresses are preferred.
Command Buttons
Refresh - Refresh the data on the screen with the present state of the data in the switch.
To Next Page
Loading...
Need help?
General