Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 149/1523
6.2.8.17 set mld maxresponse
The user can go to the CLI Interface VLAN database Mode to set the MLD Maximum Response time on
a particular VLAN, use the set mld max-response-time <vlan-id> <1-65> vlan configuration command.
Use the no set mld max-response-time <vlan-id> return to default value 10.
set mld max-response-time <vlan-id> <1-65>
no set mld max-response-time <vlan-id>
<vlan-id> - VLAN ID (Range: 1 – 4093).
<1-65> - This value must be less than the MLD Query Interval time value. The range is 1 to 65
seconds.
Default Setting
10
Command Mode
VLAN database
6.2.8.18 set ipv6 mld mcrtrexpiretime
The user can go to the CLI Interface VLAN Configuration Mode to set the Multicast Router Present
Expiration time on a particular VLAN, use the set mld mcrtrexpiretime <vlan-id> <0-3600> vlan
configuration command. Use the no set mld mcrtrexpiretime <vlan-id> to return to default value 0.
set mld mcrtrexpiretime <vlan-id> <0-3600>
no set mld mcrtrexpiretime <vlan-id>
<vlan-id> - VLAN ID (Range: 1 – 4093).
<0-3600> - The range is 0 to 3600 seconds. A value of 0 indicates an infinite time-out, i.e. no
expiration.
Default Setting
0
Command Mode
VLAN database
To Next Page
Loading...
Need help?
General