_____________________________________________________________________________
LB9 User’s Guide 1513/1523
ETS SAN Weight - Set ETS SAN Weight. The system's default ETS SAN Weight is 50. The valid
ETS SAN Weight range is 1 to 99, and ETS LAN Weight plus ETS SAN Weight must equal to 100.
Non-Configurable Data
Queue ID - Specifies the queue priority ID.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
11.10.4.2 Viewing Enhanced Transmission Selection (ETS) interface status
Non-Configurable Data
Interface - The list of ETS configurable interfaces.
Admin Mode - admin mode of specific interface.
Scheduler Type - scheduler type of specific interface.
ETS LAN Weight - LAN Weight of specific interface.
ETS SAN Weight - SAN Weight of specific interface.
Queue in LAN Priority Group - List of queues in LAN priority group.
Queue in SAN Priority Group - List of queues in SAN priority group.
Queue in IPC Priority Group - List of queues in IPC priority group.
To Next Page
Loading...
Need help?
General