Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 203/1523
6.3.3.8 server enable
This command enables/disables telnet server. If telnet server is enabled, all telnet sessions can be
established until there are no more sessions available. If telnet server is disabled, all telnet sessions are
closed.
server enable
no server enable
no - This command disables telnet server. If telnet server is disabled, all telnet sessions are droped.
Default Setting
Enabled
Command Mode
Line Vty
6.3.3.9 sessions
This command regulates new telnet sessions. If sessions are enabled, new telnet sessions can be
established until there are no more sessions available. If sessions are disabled, no new telnet sessions
are established. An established session remains active until the session is ended or an abnormal
network error ends it.
no - This command disables telnet sessions. If sessions are disabled, no new telnet sessions are
established.
Default Setting
Enabled
Command Mode
Line Vty
To Next Page
Loading...