_____________________________________________________________________________
LB9 User’s Guide 211/1523
6.3.5.2 show trapflags
This command displays trap conditions. Configure which traps the switch should generate by enabling or
disabling the trap condition. If a trap condition is enabled and the condition is detected, the switch's
SNMP agent sends the trap to all enabled trap receivers. The switch does not have to be reset to
implement the changes. Cold and warm start traps are always generated and cannot be disabled.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Authentication Flag: May be enabled or disabled. The factory default is enabled. Indicates whether
authentication failure traps will be sent.
Link Up/Down Flag: May be enabled or disabled. The factory default is enabled. Indicates whether
link status traps will be sent.
Multiple Users Flag: May be enabled or disabled. The factory default is enabled. Indicates whether
a trap will be sent when the same user ID is logged into the switch more than once at the same time
(either via telnet or serial port).
Spanning Tree Flag: May be enabled or disabled. The factory default is enabled. Indicates whether
spanning tree traps will be sent.
ACL Traps: May be enabled or disabled. The factory default is disabled. Indicates whether ACL
traps will be sent.
Captive Portal Traps: May be enabled or disabled. The factory default is disabled. Indicates
whether Captive Portal traps will be sent.
DVMRP Traps: May be enabled or disabled. The factory default is disabled. Indicates whether
DVMRP traps will be sent.
OSPFv2 Traps: May be enabled or disabled. The factory default is disabled. Indicates whether
OSPF traps will be sent.
PIM Traps: May be enabled or disabled. The factory default is disabled. Indicates whether PIM traps
will be sent.
To Next Page
Loading...
Need help?
General