Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 229/1523
6.3.6.9 snmptrap source-interface
Use this command in Global configuration mode to configure the global source-interface (Source IP
address) for all SNMP communications between the SNMP client and the server. This command takes
effect for both SNMP trap and inform client.
.
snmptrap source-interface {<slot/port> | loopback <loopback-id> | tunnel <tunnel-id> | vlan <vlan-id>}
no snmptrap source-interface
<slot/port> - Specifies the interface to use as the source interface.
<loopback-id> - Specifies the loopback interface to use as the source interface. The range of the
loopback ID is 0 to 7.
<tunnel-id> - Specifies the tunnel interface to use as the source interface. The range of the tunnel
ID is 0 to 7.
<vlan-id> - Specifies the VLAN interface to use as the source interface. The range of VLAN ID is 1
to 4093.
no - This command removes the global source-interface for all SNMP communication between the
SNMP client and the server.
Default Setting
None
Command Mode
Global Config
This feature is only support with L3 feature enabled.
To Next Page
Loading...
Need help?
General