Quanta Computer T5016-LB8D - Page 243

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 243/1523
6.3.9.2 ip ssh
This command is used to enable SSH.
Syntax
ip ssh
no ip ssh
no - This command is used to disable SSH.
Default Setting
Enabled
Command Mode
Global Config
6.3.9.3 ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1), SSH2 (2),
or both SSH 1 and SSH 2 (1 and 2) can be set.
Syntax
ip ssh protocol <protocollevel1> [protocollevel2]
<protocollevel1 - 2> - The protocol level can be set to SSH1, SSH2 or to both SSH 1 and SSH 2.
Default Setting
SSH1 and SSH2
Command Mode
Global Config