Quanta Computer T5016-LB8D - Page 248

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 248/1523
6.3.12.2 serviceport protocol
This command specifies the service port configuration protocol to be used. If you modify this value, the
change is effective immediately.
Syntax
serviceport protocol {bootp | dhcp | dhcp6 | none [dhcp6]}
<bootp> - Obtains IP address from BOOTP.
<dhcp> - Obtains IP address from DHCP.
<dhcp6> - Obtains IPv6 address from DHCPv6.
<none> - Obtains IP address by setting configuration.
<none dhcp6> - Obtains IPv6 address by setting configuration.
Default Setting
None
Command Mode
Global Config
6.3.12.3 serviceport protocol dhcp6 restart
This command is used to initiate a DHCPv6 client request by service port interface.
Syntax
serviceport protocol dhcp6 restart
Default Setting
None
Command Mode
Global Config