Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 254/1523
6.3.14.5 show sflow rate
Use this command to display the sFlow traffic rate summary on the switch.
show sflow rate interface [<slot/port>]
<slot/port> - An interface number.
no parameter - All interfaces.
Command Mode
Privilege Exec
Display Message
The number of octets rate received on the interface including framing
characters.
Unicast Packets
Received Rate
The number of unicast packets rate delivered by this sub-layer to a higher
sub-layer.
Multicast Packets
Received Rate
The number of multicast packets rate delivered by this sub-layer to a higher
sub-layer.
Broadcast Packets
Received Rate
The number of broadcast packets rate delivered by this sub-layer to a higher
sub-layer.
Discarded Packets
Received Rate
The number of inbound packets rate which were chosen to be discarded.
The number of the counter rate IfInErrors.
Unknown
Protocols Packets
Received Rate
The number of packets rate received via the interface which were discarded
because of an unknown or unsupported protocol.
The total number of octets rate transmitted out of the interface, including
framing characters.
Unicast Packets
Transmitted Rate
The total number of unicast packets rate that higher-level protocols requested
be transmitted.
Multicast Packets
Transmitted Rate
The total number of multicast packets rate that higher-level protocols
requested be transmitted.
Broadcast Packets
Transmitted Rate
The total number of broadcast packets rate that higher-level protocols
requested be transmitted.
To Next Page
Loading...
Need help?
General