To Next Page

To Previous Page

UANTA COMPUTER INC.

Layer 2/3/4 Managed Switch

_____________________________________________________________________________

LB9 User’s Guide 287/1523

no - This command removes an association between a multiple spanning tree instance and a VLAN.

The VLAN will again be associated with the common and internal spanning tree. The instance

<0-4094> is a number that corresponds to the desired existing multiple spanning tree instance. The

<1-4093> corresponds to an existing VLAN ID.

Default Setting

None

Command Mode

Global Config

This command sets the Path Cost or Port Priority for this port within the multiple spanning tree instance

or in the common and internal spanning tree. If the <1-4094> parameter corresponds to an existing

multiple spanning tree instance, then the configurations are done for that multiple spanning tree

instance. If however 0 (defined as the default CIST ID) is passed as the <1-4094>, then the

configurations are performed for the common and internal spanning tree instance.

If the ‘cost’ token is specified, this command sets the path cost for this port within a multiple spanning

tree instance or the common and internal spanning tree instance, depending on the <1-4094>

parameter. The pathcost can be specified as a number in the range of 1 to 200000000 or auto. If "auto"

is specified, the pathcost value will be set based on Link Speed.

Syntax

spanning-tree mst <1-4094> cost {<1-200000000> | auto}

no spanning-tree mst <1-4094> cost

<1-4094> - multiple spanning tree instance ID.

no - This command sets the Path Cost or Port Priority for this port within the multiple spanning tree

instance or in the common and internal spanning tree to the respective default values. If the

<1-4094> parameter corresponds to an existing multiple spanning tree instance, then the

configurations are done for that multiple spanning tree instance. If however, 0 (defined as the default

CIST ID) is passed as the <1-4094>, then the configurations are performed for the common and

internal spanning tree instance.

If the ‘cost’ token is specified, this command sets the path cost for this port within a multiple spanning

tree instance or the common and internal spanning tree instance, depending on the <1-4094>

parameter, to the default value, that is, a pathcost value based on the Link Speed.

Default Setting

Cost : auto

Command Mode

Interface Config

Quanta Computer T5016-LB8D User Manual

Questions and Answers: