Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 303/1523
Use this command to specify the physical or logical interface to use as the Syslog client source interface.
If configured, the address of source interface is used for all Syslog communications between the Syslog
server and the Syslog client. Otherwise there is no change in behavior. If the configured interface is
down, the Syslog client falls back to normal behavior.
logging syslog source-interface {<slot/port> | loopback <loopback-id> | tunnel <tunnel-id> | vlan
<vlan-id>}
no logging syslog source-interface
<slot/port> - Specifies the interface to use as the source interface.
<loopback-id> - Specifies the loopback interface to use as the source interface. The range of the
loopback ID is 0 to 7.
<tunnel-id> - Specifies the tunnel interface to use as the source interface. The range of the tunnel
ID is 0 to 7.
<vlan-id> - Specifies the VLAN interface to use as the source interface. The range of VLAN ID is 1
to 4093.
no – To remove the configured source interface for all Syslog communications between the Syslog
client and the server.
Default Setting
None
Command Mode
Globla Config
To Next Page
Loading...
Need help?
General