Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 312/1523
6.7.2.2 Unlock a locked user account
The user can go to the CLI Global Configuration Mode to unlock a locked user account, use the
username <name> unlock global configuration command.
username <username> unlock
<name> - is a user name (Range: up to 8 characters).
Default Setting
None
Command Mode
Global Config
6.7.2.3 username snmpv3 authentication
This command specifies the authentication protocol to be used for the specified login user. The valid
authentication protocols are none, md5 or sha. If md5 or sha are specified, the user login password will
be used as the snmpv3 authentication password. The <username> is the login user name for which the
specified authentication protocol will be used.
username snmpv3 authentication <username> {none | md5 | sha}
no username snmpv3 authentication <username>
<username> - is the login user name.
md5 - md5 authentication method.
sha - sha authentication method.
none - no use authentication method.
no - This command sets the authentication protocol to be used for the specified login user to none.
The <username> is the login user name for which the specified authentication protocol will be used.
Default Setting
No authentication
Command Mode
Global Config
To Next Page
Loading...