_____________________________________________________________________________
LB9 User’s Guide 368/1523
6.8.4.3 captive-portal configuration mode
Use this command to enter the Captive Portal Instance Mode.
The captive portal configuration, identified by CP ID 1, is the default CP configuration. You can create up
to nine additional captive portal configurations. The system supports a total of ten CP configurations.
The Captive Portal ID <cp-id> variable is a number in the range of 1-10.
Default Setting
None
Command Mode
Captive Portal Config
6.8.4.4 Enable/Disable captive-portal
This command globally enables the captive portal feature on the switch.
To Next Page
Loading...