EasyManuals Logo

Quanta Computer T5016-LB8D User Manual

Default Icon
1523 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #424 background imageLoading...
Page #424 background image
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 424/1523
6.8.8.2 Configuration Commands
6.8.8.2.1 dos-control sipdip
This command enables Source IP Address = Destination IP Address (SIP=DIP) Denial of Service
protection. If the mode is enabled, Denial of Service prevention is active for this type of attack. If packets
ingress with SIP=DIP, the packets will be dropped if the mode is enabled.
Syntax
dos-control sipdip
no dos-control sipdip
no - This command disables Source IP Address = Destination IP Address (SIP=DIP) Denial of
Service prevention.
Default Setting
Disabled
Command Mode
Global Config
6.8.8.2.2 dos-control tcpfrag
This command enables Minimum TCP Header Size Denial of Service protection. If the mode is enabled,
Denial of Service prevention is active for this type of attack. If packets ingress having a TCP Header Size
smaller then the configured value, the packets will be dropped if the mode is enabled. The default is
disabled. If you enable dos-control tcpfrag, but do not provide a Minimum TCP Header Size, the system
sets that value to 20.
Syntax
dos-control tcpfrag [<0-255>]
no dos-control tcpfrag
<0-255> - This command sets minimum TCP header length
no - This command sets Minimum TCP Header Size Denial of Service protection to the default value
of disabled.
Default Setting
Disabled, 20
Command Mode
Global Config

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quanta Computer T5016-LB8D and is the answer not in the manual?

Quanta Computer T5016-LB8D Specifications

General IconGeneral
BrandQuanta Computer
ModelT5016-LB8D
CategorySwitch
LanguageEnglish