_____________________________________________________________________________
LB9 User’s Guide 474/1523
6.12.2.5 lldp transmit-mgmt
This command uses to include transmission of the local system management address information in the
LLDPDUs.
no - This command is used to cancel inclusion of the management information in LLDPDUs.
Default Setting
None
Command Mode
Interface Config
6.12.2.6 lldp transmit-tlv
This command is used to specify which optional type length values (TLVs) in the 802.1AB basic
management set are transmitted in the LLDPDUs. Use sys-name to transmit the system name TLV. To
configure the system name, please refer to “snmp-server” command. Use sys-descto transmit the
system description TLV. Use sys-cap to transmit the system capabilities TLV. Use port-desc to transmit
the port description TLV. To configure the port description, please refer to “description” command. Use
org-spec to transmit the organization specific TLV.
lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc] [org-spec]
no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc] [org-spec]
no - This command is used to remove an optional TLV from the LLDPDUs. Use the command
without parameters to remove all optional TLVs from the LLDPDU.
Default Setting
None
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General