Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 478/1523
6.12.2.11 lldp med transmit-tlv
The user can go to the CLI Interface Configuration Mode to set Type Length Values (TLVs) in the LLDP
MED, use the lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory]
[location][network-policy] Interface configuration command. Use the no lldp med transmit-tlv
[capabilities] [ex-pd] [ex-pse] [inventory] [location][network-policy] to remove the TLVs.
lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory] [location]
[network-policy]
no lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory] [location]
[network-policy]
capabilities -Transmit the LLDP capabilities TLV.
ex-pd - Transmit the LLDP extended PD TLV.
ex-pse - Transmit the LLDP extended PSE TLV.
inventory - Transmit the LLDP inventory TLV.
location - Transmit the LLDP location TLV.
network-policy - Transmit the LLDP network policy TLV.
Default Setting
None
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General