_____________________________________________________________________________
LB9 User’s Guide 521/1523
6.16.8.2 traceroute ipv6
This command is used to discover the routes that packets actually take when traveling to their
destination through the network on a hop-by-hop basis. The <ipv6-address|hostname> parameter must
be a valid IPv6 address|hostname.
<ipv6-address|hostname> - A valid IPv6 address or hostname.
<ipaddr> - The IP address or destination host you want to trace.
<initTtl> - The Use initTtl to specify the initial time-to-live (TTL), the maximum number of router hops
between the local and remote system. Range is 1 to 255.
<maxTtl> - Use maxTtle to specify the maximum TTL. Range is 1 to 255.
<interval> - Use interval to specify the time between probes, in seconds. Range is 1 to 60 seconds.
<count> - Use the optional count parameter to specify the number of probes to send for each TTL
value. Range is 1 to 10 probes.
Default Setting
None
Command Mode
Privileged Exec
To Next Page
Loading...
Need help?
General