Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 528/1523
6.16.17.2 AutoInstall State: The status of the current or most recently completed AutoInstall
session.Configuration Commands
6.16.17.2.1 boot-system autoinstall
Use this command to operationally start or stop the AutoInstall process on the switch. The command is
non-persistent and is not saved in the startup or running configuration file.
boot-system autoinstall { start | stop }
Default Setting
None
Command Mode
Privileged Exec
Display Message
None
6.16.17.2.2 boot-system host autoinstall
Use this command to enable AutoInstall on the switch for the next reboot cycle. The command does not
change the current behavior of AutoInstall and saves the command to NVRAM.
boot-system host autoinstall
no boot-system host autoinstall
no - Use this command to disable AutoInstall for the next reboot cycle.
Default Setting
None
Command Mode
Privileged Exec
Display Message
None
To Next Page
Loading...
Need help?
General