Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 547/1523
6.17.2.7 ip dhcp snooping binding
This command configures the static DHCP Snooping binding..
ip dhcp snooping binding <mac-address> vlan <vlan id> <ip address> interface <interface id>
no ip dhcp snooping binding <mac-address>
no - This command removes the DHCP static entry from the DHCP Snooping database.
Default Setting
None
Command Mode
Global Config
6.17.2.8 ip dhcp snooping limit
This command controls the rate at which the DHCP Snooping messages come. The default rate is 15
pps with a range from 0 to 300 pps. The default burst level is 1 second with a range of 1 to 15 seconds.
ip dhcp snooping limit {rate <pps> [burst interval <seconds>]}
no ip dhcp snooping limit
no - This command sets the rate at which the DHCP Snooping messages come, and the burst level,
to the defaults.
Default Setting
15 pps for rate limiting and 1 sec for burst interval
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General