Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 583/1523
6.20.2.15 match protocol
This command adds to the specified class definition a match condition based on the value of the IP
Protocol field in a packet using a single keyword notation or a numeric value notation.
match protocol {<protocol-name> | <0-255>}
<protocol-name> is one of the supported protocol name keywords. The currently supported values
are: icmp, igmp, ip, tcp, udp. Note that a value of ip is interpreted to match all protocol number
values. To specify the match condition using a numeric value notation, the protocol number is a
standard value assigned by IANA and is interpreted as an integer from 0 to 255.
This command does not validate the protocol number value against the current list defined
by IANA.
Default Setting
None
Command Mode
Class-Map Config / Ipv6-Class-Map Config
To Next Page
Loading...