_____________________________________________________________________________
LB9 User’s Guide 586/1523
6.20.2.18 match srcl4port
This command adds to the specified class definition a match condition based on the source layer 4 port
of a packet using a single keyword or numeric notation or a numeric range notation.
<portkey> is one of the supported port name keywords (listed below).
The currently supported
<portk
ey> values are: dom
ain, echo, ftp, ftpd
ata, http, sm
tp, snmp, telnet,
tftp, www. Each of these translates into its equivalent port number, which is used as both the start
and end of a port range.
To specify the match condition as a numeric value, one layer 4 port number is required. The port number
is an integer from 0 to 65535.
To specify the match condition as a range, two layer 4 port numbers are required and together they
specify a contiguous port range. Each port number is an integer from 0 to 65535, but with the added
requirement that the second number be equal to or greater than the first.
Default Setting
None
Command Mode
Class-Map Config / IPv6-Class-Map Config
To Next Page
Loading...
Need help?
General