_____________________________________________________________________________
LB9 User’s Guide 60/1523
6.2.1.2 show interface counters
This command displays a summary of statistics for a specific interface or all interfaces.
<slot/port> - is the desired interface number.
<portchannel-id> - is the desired port-channel interface number. The range of the port-channel ID is
1 to 64.
no paramter - Displays statistics information for all interfaces.
Default Setting
None
Command Mode
Privileged Exec
Display Message
The display parameters when the argument is '<slot/port>' or port-channel are as follows:
Packets Received Without Error: The total number of packets (including broadcast packets and
multicast packets) received by the processor.
Packets Received With Error: The number of inbound packets that contained errors preventing
them from being deliverable to a higher-layer protocol.
Broadcast Packets Received: The total number of packets received that were directed to the
broadcast address. Note that this does not include multicast packets.
Packets Transmitted Without Error: The total number of packets transmitted out of the interface.
Transmit Packets Errors: The number of outbound packets that could not be transmitted because
of errors.
Collisions Frames: The best estimate of the total number of collisions on this Ethernet segment.
Time Since Counters Last Cleared: The elapsed time, in days, hours, minutes, and seconds since
the statistics for this port were last cleared.
The display parameters if no argument is used are as follows:
Interface: The physical slot and physical port or the logical slot and logical port.
Packets Received Without Error: The total number of packets (including broadcast packets and
multicast packets) received.
To Next Page
Loading...
Need help?
General