_____________________________________________________________________________
LB9 User’s Guide 634/1523
6.23.1.3 show queue trust
This command displays the current trust mode setting for a specific interface. The slot/port parameter is
optional and is only valid on platforms that support independent per-port class of service mappings. If
specified, the port trust mode of the interface is displayed. If omitted, the port trust mode of each
interface in the system is shown. If the platform does not support independent per-port class of service
mappings, the output represents the system-wide port trust mode used for all interfaces.
< slot/port > - The interface number.
<portchannel-id> - The port-channel interface number. The range of port-channel ID is 1 to 64.
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
Class of Service Trust Mode: The trust mode of this interface.
Non-IP Traffic Class: The traffic class used for non-IP traffic. This is only displayed when the COS
trust mode is set to either 'trust ip-dscp' or 'trust ip-precedence'.
Untrusted Traffic Class: The traffic class used for all untrusted traffic. This is only displayed when
the COS trust mode is set to 'untrusted'.
To Next Page
Loading...
Need help?
General