_____________________________________________________________________________
LB9 User’s Guide 720/1523
7.3.2.7 area nssa
area nssa command configures the specified areaid to function as an NSSA. no area nssa command
disables nssa from the specified area id.
Default Setting
None
Command Mode
Router OSPF Config Mode
7.3.2.8 area nssa default-info-originate
area nssa default-info-originate command configures the metric value and type for the default route
advertised into the NSSA. The optional metric parameter specifies the metric of the default route and is
to be in a range of 1-16777214. If no metric is specified, the default value is ****. The metric type can be
comparable (nssa-external 1) or non-comparable (nssa-external 2). This command disables the default
route advertised into the NSSA . no area nssa default-info-originate command disables the default
route advertised into the NSSA.
area <areaid> nssa default-info-originate [<metric>] [{comparable | noncomparable}]
no area <areaid> nssa default-info-originate [<metric>] [{comparable | noncomparable}]
To Next Page
Loading...
Need help?
General