Quanta Computer T5016-LB8D - Page 726

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 726/1523
7.3.2.19 area virtual-link hello-interval
area virtual-link hello-interval command configures the hello interval for the OSPF virtual interface on
the virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID
of the neighbor. The range for <seconds> is 1 to 65535. no area virtual-link hello-interval command
configures the default hello interval for the OSPF virtual interface on the virtual interface identified by
<areaid> and <neighbor>. The <neighbor> parameter is the Router ID of the neighbor
Syntax
area <areaid> virtual-link <neighbor> hello-interval <1-65535>
no area <areaid> virtual-link <neighbor> hello-interval
Default Setting
10
Command Mode
Router OSPF Config Mode
7.3.2.20 area virtual-link retransmit-interval
area virtual-link retransmit-interval command configures the retransmit interval for the OSPF virtual
interface on the virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor. The range for seconds is 0 to 3600.. no area virtual-link retransmit -interval
command configures the default retransmit interval for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID of the neighbor
Syntax
area <areaid> virtual-link <neighbor> retransmit-interval <seconds>
no area <areaid> virtual-link <neighbor> retransmit-interval
Default Setting
5
Command Mode
Router OSPF Config Mode