Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 738/1523
7.3.2.43 ip ospf retransmit-interval
ip ospf retransmit command sets the OSPF retransmit Interval for the specified interface. The
retransmit interval is specified in seconds. The value for <seconds> is the number of seconds between
link-state advertisement retransmissions for adjacencies belonging to this router interface. This value is
also used when retransmitting database description and link-state request packets. Valid values range
from 0 to 3600 (1 hour). no ip ospf retransmit command sets the default OSPF retransmit Interval for
the specified interface.
ip ospf retransmit-interval <0-3600>
no ip ospf retransmit-interval
Default Setting
5
Command Mode
Interface Config
7.3.2.44 ip ospf transmit-delay
ip ospf transmit-delay command sets the OSPF Transit Delay for the specified interface. The transmit
delay is specified in seconds. In addition, it sets the estimated number of seconds it takes to transmit a
link state update packet over this interface. Valid values for <seconds> range from 1 to 3600 (1 hour). no
ip ospf transmit-delay command sets the default OSPF Transit Delay for the specified interface
ip ospf transmit-delay <1-3600>
no ip ospf transmit-delay
Default Setting
1
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General