Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 758/1523
7.6.2.7 hostrouteaccept
This command enables the RIP hostroutesaccept mode.
hostrouteaccept
no hostrouteaccept
no - This command disables the RIP hostroutesaccept mode.
Default Setting
Enabled
Command Mode
Router RIP Config
7.6.2.8 split-horizon
This command sets the RIP split horizon mode. None mode will not use RIP split horizon mode. Simple
mode will be that a route is not advertised on the interface over which it is learned. Poison mode will be
that routes learned over this interface should be re-advertised on the interface with a metric of infinity
(16).
split-horizon {none | simple | poison}
no split-horizon
none - This command sets without using RIP split horizon mode.
simple - This command sets to use simple split horizon mode.
poison - This command sets to use poison reverse mode.
no - This command cancel to set the RIP split horizon mode and sets none mode.
Default Setting
Simple
Command Mode
Router RIP Config
To Next Page
Loading...
Need help?
General