_____________________________________________________________________________
LB9 User’s Guide 761/1523
7.6.2.11 ip rip authentication
This command sets the RIP Version 2 Authentication Type and Key for the specified interface. The value
of <type> is either none, simple, or encrypt.
The value for authentication key [key] must be 16 bytes or less. The [key] is composed of standard
displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the value of <type> is
encrypt, a keyid in the range of 0 and 255 must be specified.
none - This command uses no authentication.
simple - This command uses simple authentication for RIP authentication .
encrypt - This command uses MD5 encryption for RIP authentication.
<key> - 16 alpha-numeric characters to be used for authentication key.
<keyid> - a value in the range of 0 – 255 to be used for MD5 encryption.
no - This command sets the default RIP Version 2 Authentication Type.
Default Setting
None
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General