Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 775/1523
7.9.2.2 ip vrrp ip
This commands also designates the configured virtual router IP address as a secondary IP address on
an interface.
ip vrrp <1-255> ip <addr> [secondary]
no ip vrrp <1-255>
ip <addr> [secondar
y]
<1-255> - The range of virtual router ID is 1 to 255.
<addr> - Secondary IP address of the router ID.
<no> - This command removes all VRRP configuration details of the virtual router configured on a
specific interface.
Default Setting
None
Command Mode
Interface Config
7.9.2.3 ip vrrp mode
This command enables the virtual router configured on the specified interface. Enabling the status field
starts a virtual router.
ip vrrp <1-255> mode
no ip vrrp <1-255> mode
<1-255> - The range of virtual router ID is 1 to 255.
<no> - Disable the virtual router configured on the specified interface. Disabling the status field stops
a virtual router.
Default Setting
Disabled
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General