_____________________________________________________________________________
LB9 User’s Guide 794/1523
8.2.1.4 show ip igmp interface membership
This command displays the list of interfaces that have registered in the multicast group.
< multiipaddr > - A multicast IP address..
[detail] - Display details of subscribed multicast groups.
Default Setting
None
Command Mode
Privileged Exec
User EXEC
Display Message
Iinterface: Valid slot and port number separated by forward slashes.
Interface IP: This displays the IP address of the interface participating in the multicast group.
State: This displays whether the interface has IGMP in Querier mode or Non-Querier mode.
Group Compatibility Mode: The group compatibility mode (v1, v2 or v3) for the specified group on
this interface.
Source Filter Mode: The source filter mode (Include/Exclude) for the specified group on this
interface. This is “-----” for IGMPv1 and IGMPv2 Membership Reports.
If detail is specified, the following fields are displayed:
Interface: Valid slot and port number separated by forward slashes.
Group Compatibility Mode: The group compatibility mode (v1, v2 or v3) for the specified group on
this interface.
Source Filter Mode: The source filter mode (Include/Exclude) for the specified group on this
interface. This is “-----” for IGMPv1 and IGMPv2 Membership Reports.
Source Hosts: This displays the list of unicast source IP Addresses in the group record of the
IGMPv3 Membership Report with the specified multicast group IP Address. This is “-----” for IGMPv1
and IGMPv2 Membership Reports.
Expiry Time: This displays the amount of time remaining to remove this entry before it is aged out.
This is “- ----” for IGMPv1 and IGMPv2 Membership Reports.
To Next Page
Loading...
Need help?
General