Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 842/1523
8.6.2.7 ipv6 pim dr-priority
Use this command to set the priority value for which a router is elected as the designated router (DR).
This command can be configured on a single interface or a range of interfaces.
ipv6 pim dr-priority <0-4294967294>
no ipv6 pim dr-priority
no - Use this command to disable the interface from being the BSR border.
Default Setting
1
Command Mode
Interface Config
8.6.2.8 ipv6 pim join-prune-interval
This command is used to configure the interface join/prune interval for the PIM-SM router on an interface
or range of interfaces. The join/prune interval is specified in seconds. This parameter can be configured
to a value from 0 to 18000.
ipv6 pim join-prune-interval <0-18000>
no ipv6 pim join-prune-interval
no - Use this command to set the join/prune interval to the default value.
Default Setting
60
Command Mode
Interface Config
To Next Page
Loading...