Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 861/1523
9.1.2.3 tunnel destination
This command specifies the destination transport address of the tunnel.
tunnel destination {<ipv4-address>}
<ipv4-address> - A valid IP Address.
Default Setting
None
Command Mode
Interfacel Tunnel Mode
9.1.2.4 tunnel mode ipv6ip
This command specifies the mode of the tunnel. With the optional 6to4 argument, the tunnel mode is set
to 6to4 automatic. Without the optional 6to4 argument, the tunnel mode is configured.
tunnel mode ipv6ip [6to4]
Default Setting
None
Command Mode
Interfacel Tunnel Mode