Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 884/1523
9.3.2.10 ipv6 nd managed-config-flag
This command sets the “managed address configuration” flag in router advertisements. When the value
is true, end nodes use DHCPv6. When the value is false, end nodes automatically configure addresses.
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
no – This command resets the “managed address configuration” flag in router advertisements to the
default value.
Default Setting
False
Command Mode
Interface Config
9.3.2.11 ipv6 nd ns-interval
This command sets the interval between router advertisements for advertised neighbor solicitations, in
milliseconds. An advertised value of 0 means the interval is unspecified.
ipv6 nd ns-interval { <1000 – 4294967295> | 0 }
no ipv6 nd ns-interval
no – This command resets the neighbor solicit retransmission interval of the specified interface to
the default value.
Default Setting
0
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General